ESTIMATE OF ERRORS OF PROCESSING OF PARTS FROM TOUGH TITANIUM ALLOYS

Authors

Barakaev Nusratilla Rajabovich Doctor of technical sciences professor
Sayliev Ismat Ismatovich Probationer teacher
Primkulov Azamat Barotovich Undergraduate Bukhara Engineering-Technological Institute

Keywords:

Characteristics of processing errors, accuracy of dimensions, process equipment accuracy errors, systematic errors

Abstract

The article covers the analysis of components of the cutting errors before choosing the type of control and presents a model of processing error based on analysis of reasons that cause deviation from linear dimensions during machining.

Downloads

pdf

Published

2021-05-31

Issue

Vol. 2 No. 5 (2021): ESJ

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Most read articles by the same author(s)

Barakaev Nusratilla Rajabovich, Odinaev Rustam Sobirovich, Safarov Bekzod Kuzi ugli, INSTALLATION OF PALLET FIXTURE ON MACHINE TABLE , European Scholar Journal: Vol. 2 No. 5 (2021): ESJ
Barakaev Nusratilla Rajabovich, Isamov Rayim Nasimovich, Rakhmonov Sulton Kurbon ugli, IMPROVEMENT OF QUALITY OF INTERNAL CYLINDRICAL SURFACES , European Scholar Journal: Vol. 2 No. 6 (2021): ESJ
Barakaev Nusratilla Rajabovich, Urinov Nasillo Fayzilloevich, Shomuradova Indra Fozilovna, TECHNOLOGY OF COATING ON GUN DRILLS , European Scholar Journal: Vol. 2 No. 6 (2021): ESJ
Barakaev Nusratilla Rajabovich, Urinov Nasillo Fayzilloevich, Sohibov Ibodullo Adizmurodovich, DEVELOPMENT OF TECHNOLOGICAL REGULATIONS FOR PRODUCTION OF LAMELLAR KNIVES USING EXPERIMENTAL INSTALLATION , European Scholar Journal: Vol. 2 No. 5 (2021): ESJ
Barakaev Nusratilla Rajabovich, Urinov Nasillo Fayzilloevich, Amonov Mahmud Idris ugli, RESEARCH THE INFLUENCE OF FRICTION ON FEATURES OF MOLDED MACARONI PRODUCTS , European Scholar Journal: Vol. 2 No. 5 (2021): ESJ